top of page
hompage

How To Install

Pro Install Tutorial

Step 1

Shut Off Water & Relieve Water System Pressure

  • Turn OFF the main water shutoff valve to the home

  • Open one faucet on the lowest level.

  • Open one faucet on the highest level.

*This begins draining your system

Clips.MOV

Step 2

Position Template & Mark Pipes

  • Snap the WOLF template onto the copper pipe.

  • Ensure the template sits flat and secure before marking.

  • Using the template, mark the left cut line.

  • Using the template, mark the right cut line.

  • Using the template, mark the center drain location.

  • Remove the template after all marks are made.

Step 2.mp4

Step 3

Install Temporary Drain

  •  Install the temporary drain valve at the center mark.

  • Attach tubing to the drain valve.

  • Route the tubing into a bucket.

Step 3.mp4

Step 4

Fully Drain Pipe

  •  Install the temporary drain valve at the center mark.

  • Attach tubing to the drain valve.

  • Route the tubing into a bucket.

Step 4 Drain the pipe.mp4

Step 5

Cut Pipe

  • Using the pipe cutter, cut the pipe at the left marked line.

  • Using the pipe cutter, cut the pipe at the right marked line.

  • Remove the center section of pipe.

  • Ensure both cuts are straight and clean.

 

Important: Wear gloves when handling cut pipe to avoid injury from sharp edges.

Step_5_cut_pipe_1.5x.mp4

Step 6

Prepare Pipe (Critical)

  • Deburr both pipe ends.

  • Remove sharp edges from the inside and outside of both pipe ends.

  • Wipe both pipe ends clean with a towel or rag.

  • Remove copper shavings, debris, and moisture from both pipe ends.

  • Clean the pipe ends until the copper is shiny.

 

Important: Proper pipe preparation is required before inserting the valve assembly and couplings.

Step_6_Deburr_25s.mp4

Step 7

Insert Valve Assembly & Slide Couplings

  • Insert the WOLF valve assembly between the two pipe ends.

  • Ensure the valve assembly is facing the correct direction.

  • Ensure the valve is positioned straight before moving the couplings.

  • Slide the left coupling over the left pipe end and onto the valve stub.

  • Slide the right coupling over the right pipe end and onto the valve stub.

  • Move both couplings until the pipe is fully inserted to the indicator lines.

Insert Valve.mp4

Step 8

Verify Alignment (Critical)

  • Check that the valve is upright.

  • Check that the flow direction is correct.

  • Check that both couplings are fully seated to the indicator lines.

  • Check that the pipe and valve assembly remain straight.

Important: Do NOT press the fittings if alignment is incorrect or if the indicator lines are not fully covered.

Verify Alignment.mp4

Step 9

Press Fittings

  • Using the ProPress or compatible press tool, press the left fitting.

  • Using the ProPress or compatible press tool, press the right fitting.

  • After pressing, mark each fitting with an 'X' to confirm it has been pressed.

Propress_25s.mp4

Step 10

Restore Water & Check Leak

  • Slowly turn the main water supply back on.

  • Inspect both press connections carefully.

  • Inspect the valve assembly carefully.

  • If all connections remain dry, installation is complete.

Restore Water.mp4

Step 11

Attach & Power Resideo Device

  • Plug in and complete setup of the smart valve device, if applicable.

 

Important: The Temporary drain section is removed during installation and does not remain in the final system

Attach Device.mp4

Looking to Install the DIY Kit?

How to Install DIY Kit
Systems
Home
bottom of page